1. Place the rotating part of the external mechanical
seal (08) on the shaft without fixing it.
2.
Place the O-ring (80C) over the seal cover align
-
ment (03).
3.
Place the cap (10) over this alignment and fix it to
the seal cover (03) using hexagonal screws (52)
and washers (53).
4.
Mount the fixed part of the external mechanical
seal (08) inside the seal cover (03).
5. Mount, carefully, this assembly on the bearing
support alignment (06).
6. Place the rotating part of the external mechanical
seal (08A) until it touches the fixed part (08A) and
fixes it with the pins.
7. Mount the internal mechanical seal following the
instructions of the chapter
assembly of the single mechanical seal
.
02.002.32.0017
02.002.32.0015
02.002.32.0016
2.
Mount the fixed part of the external mechanical seal (08A) in the cover (03A) and then put the
cover on the lantern (04).
3. Mount the internal mechanical seal following the instructions of the chapter
assembly of the single mechanical seal
.
1.
Place the rotating part of the external mechanical seal (08) on the shaft (05) and fix it according to
the assembly measure indicated in the following technical section:
4.
Disassemble the pins of the rotating part of the bottom mechanical seal (08) and slide it through
the shaft (05).
8.10.3. Assembly cooled mechanical seal for the M-226 blender
8.10.4. Assembly cooled mechanical seal for the M-440 blender
Maintenance
INOXPA S.A.U.
02.002.30.02EN · (0) 2021/04
20