INOXPA LM 1.10-4030-1-200, Installation, Service And Maintenance Instructions

Page: 15 / 24

Troubleshooting
INOXPA S.A.U.
20.025.30.01EN · (0) 2019/04 15
7. Troubleshooting
The attached table lists solutions to problems that may arise while operating the agitator. It is assumed that the
agitator has been properly installed and that is has been selected correctly for the specific application.
Contact INOXPA if technical assistance is required.
Motor overload
Insufficient agitation
Vibrations and noise
Leaks
PROBABLE CAUSES SOLUTIONS
 
Viscosity of the liquid too high
Reduce the viscosity, e.g. by heating
the liquid

High density Increase motor power

Tank too big for the chosen agitator Check with the technical department

Wrong direction of rotation Change direction of rotation

Agitator speed too low Increase the speed

Liquid level insufficient or none Check liquid level in the tank

Shaft bended Replace the shaft

Critical speed Check with the technical department

Worn bearings Replace the bearings agitator

Lip seal worn or damaged
If the lip seal is worn, replace it.
If the lip seal is damaged, consult the
technical department.

O-rings not the right ones for the
liquid Fit the proper O-rings, check with the
supplier
If the problems persist stop using the agitator immediately. Contact the agitator manufacturer or the
representative.