Safety
INOXPA S.A.U.
10.250.30.02EN · (0) 2019/09
5
3. Safety
3.1. WARNING SYMBOLS
Safety hazard for people in general and/or for equipment
Electric hazard
Important instruction to prevent damage to the equipment and its function
3.2. GENERAL SAFETY INSTRUCTIONS
Read the instruction manual carefully before installing and starting the valve. Contact INOXPA in
case of doubt.
3.2.1. During installation
The installation and use of the valve should always be in accordance with applicable regulations in
regard to health and safety.
Before starting up the valve, check that it is assembled correctly and its shaft is perfectly aligned.
Incorrect alignment and/or excessive stress during coupling can cause serious mechanical
problems in the valve.
3.2.2. During operation
should always be observed.
The specified limit values shall never be exceeded under any circumstance.
NEVER touch the valve and/or piping that is in contact with the fluid during operation. If the
process involves hot products, there is a risk of burns.
The valve contains parts that move in a linear fashion. Do not place hands or fingers in the valve
closing area. This can cause serious injury.
3.2.3. During maintenance
should always be observed.
NEVER disassemble or remove the valve until the pipes have been emptied. Bear in mind that the
fluid in the pipe may be hazardous or extremely hot. Consult the regulations in effect in each
country for these cases.
Inside the actuator, there is a spring with an applied load, and the steps specified in this manual
must be followed when performing maintenance operations to avoid injury. Do not leave loose
parts on the floor.
All electrical work must be carried out by authorised personnel.
ATTENTION
