Inovonics 235, Operating And Maintenance Instruction Manual

Page: 9 / 35

— — 7
Section II
INSTALLATION
UNPACKING AND INSPECTION
Immediately upon receipt of the equipment, inspect carefully for any
shipping damage. If damage is suspected, notify the carrier at once,
then contact Inovonics.
We recommend that you retain the original shipping carton and packing
materials for return or reshipment, if necessary. In the event of return
for Warranty repair, shipping damage sustained as a result of improper
packing for return may invalidate the Warranty!
IT IS VERY IMPORTANT
that the Warranty Registration
Card found at the front of this Manual be completed and
returned. Not only does this assure coverage of the equip-
ment under terms of the Warranty, and provide some means
of trace in the case of lost or stolen gear, but the user will
automatically receive specific SERVICE OR MODIFICA-
TION INSTRUCTIONS should they be issued by Inovonics.
MOUNTING
Rack
Requirement
The Model 235 mounts in a standard 19-inch equipment rack and
requires only 1¾ inches (1U) of vertical rack space. Plastic “finishing”
washers are recommended to protect the painted finish around the
mounting holes.
Heat Dissipation
Consuming less power than a counter-top coffee grinder, the 235, itself,
generates negligible heat. The unit is specified for operation within an
ambient temperature range extending from freezing to 120
°
F/50
°
C.
But because adjacent, less efficient equipment may radiate substantial
heat, be sure that the equipment rack is adequately ventilated to keep
its internal temperature below the specified maximum ambient.
AC (MAINS) POWER
As delivered
Unless specifically ordered for export shipment, the Model 235 is set at
the factory for operation from 115V, 50/60Hz AC mains. The rear-
panel designation next to the fuseholder will confirm both the mains
voltage selected and the value of a proper fuse.