User’s Manual -
RNC-1004WL Wireless Router - www.inovia.co.kr
the local PCs
* AC power socket: only use the power adapter supplied with the
54Mbps Wireless Router, use of a different adapter may result in
product damage.
* Factory Default Reset button
Use the Factory Default Reset button:
1) Keep the power on and the router at work, press the
reset button for about 5 seconds.
2) Release it, and wait for the router restart automatically.
2.2 System Requirements
* Broadband Internet Access Service (DSL/Cable/Ethernet)
* One DSL/Cable modem that has an RJ45 connector (you do not
need it if you connect the router to Ethernet)
* Each PC on the LAN needs a working Ethernet Adapter and an
Ethernet cable with RJ45 connectors
* TCP/IP protocol must be installed on each PC
* Web browser, such as Microsoft Internet Explorer 5.0 or later,
Netscape Navigator 6.0 or later
2.3 Installation Environment Requirements
* Not in direct sunlight or near a heater or heating vent
* Not cluttered or crowded. There should be at least 2 inches (5
cm) of clear space on all sides of the router
* Well ventilated (especially if it is in a closet)
* Operating temperature: 0℃~40℃
* Operating Humidity: 5%~90%RH, Non-condensing
2.4 Connecting the Router
Before you install the router, you should connect your PC to
the Internet through your broadband service successfully. If there is
any problem, please contact your ISP. After that, please install the
router according to the following steps. Don't forget to pull out the
power plug and keep your hands dry.
1. Power off your PC(s), Cable/DSL modem, and the router.
2. Locate an optimum location for the router. The best place is
usually near the center of the area in which your PC(s) will
wirelessly connect. The place must accord with the Installation
Environment Requirements.
3. Adjust the direction of the antenna. Normally, upright is a good
direction.
7