Inova OnTime Digital Clock Owner's Manual
All claims based on information publicly available at time of printing. All other product or service names mentioned in this document may be
trademarks of the companies with which they are associated.
© 2007 Inova Solutions. | All rights reserved. 6.12.2007 | page 24
Appendix A: Digital Clock Configuration
This section summarizes the configuration options available with the Digital Clock.
Condition Solution
Get help for clock commands
?
or
help
To see a list of all the telnet command options for which help is
available.
To see help for a particular command option, type the command option
help
followed by
?.
For example, to see help for the
display
option:
display ?
or
help display
Determine the IP Address of a
Clock
If the IP Address of each clock has not been recorded during installation, it is
suggested to follow this procedure.
1.
Lift UP gently on the unit to free the keyholes at the rear of the clock
from the mounting hardware.
2.
Disconnect the network cable from the clock in question and count to
five.
Replace the network cable and watch the face of the clock. It will display its IP
address as it boots.
Display the configuration settings
for clock
config
Display all configuration parameters except those sent by the DHCP
server. Use the DHCP config command to view these superseding options
View or change the Daylight
Saving Time (DST) setting
No Daylight Saving Time -
Type the command to disable DST:
dst –none
Press the Enter key.
US and Canada -
Type:
dst -rule -1 8 2 2 1 1 10 2
Press the Enter key.
European -
Type:
dst -rule 1 -1 2 1 1 -1 9 1
Press the Enter key
.
Other Locations –
The support web site at
www.buyinova.com
contains a DST
calculator which can compute the correct DST configurations string for you
location. Obtain the correct string and enter it with the
dst –rule
command.
