Inoksan 7FE100-200, Instruction Manual

Page: 12 / 46

10
INSTALLATION INSTRUCTIONS
GB
WARNINGS
Installation, modifications and maintenance of the
appliance must be carried out by authorised personnel
in compliance with current safety standarts.
The manufacturer declines all responsibility for failure
to comply with these obligations.
• The instructions contained in this manual give
important regarding security for installing and
maintaining the appliance. The manufacturer
recommends that this manual be carefully stored
in the work zone where it can be consulted by
technicians and workers.
• Electric connection of the appliance must be
according to the instructions given on the technical
data table and electric scheme.
• Disrespect of the instruction given by producer
with the appliance (Use, maintenance, electric
connecting, technical data table and data plate) may
compromise the appliance safety and will result in
immediate loss of the warranty. The manufacturer
declines all responsibility for injury or damage
to persons or things, due to disrespect of the
instructions.
INSTALLATION
Positioning
• The appliance should be placed under an exhaust
hood to remove smoke and smell which may ccur
during the cooking process.
• Position the appliance at least 10 cm from
surrounding walls. This distance may be reduced if
the walls are flameproof or protected by insulating
material.
Assembly (Fig.-1)
• Remove the protective nylon on the appliance. If
sticky particles left on the appliance, clean them
with a suitable solvent.
• If you will use the appliance with cupboard, use
reference pins to put the appliance on cupboard and
set the balance of unit with foot(4 pcs.) on flat floor.
• If you will use the appliance on support leg system,
use reference pins to put the appliance on leg
system.
• In the case of cantilever installations, refer to the
corresponding instructions.
Joining appliances together in line (Fig. 2)
• Place the appliances side by side and level to the
same height.
• Join the appliances by use of the special fixing holes
on the side of the fryer.
Electrical connections
• The appliance is designed to operate at the voltage
indicated on the data plate.
• Each appliance must be connected to the power
supply by a suitably dimensioned independent
line (the total power is indicated in the “Technical
data” table). A flexible rubber cable with insulation
specifications not lower than type H 07 RN-F must
be used for connection to the temiinals.
• The length of conductors between the cable clamp
and terminals must be such that the live wires are
pulled taut before the ground wire (yellow-green) if
the cable is worked loose from the clamp.
• Multi-pole main isolating switches of suitable
current ratin. (with minimum contact-breaking
distance of 3 mm) must be installed, as well as
automatic residual current switches of suitable high
sensitivity.
• There should be a automate fuse between the
appliance and the network.
• Voltage changes should not exceed
±
%10V.