User Guide
33
Than or Equal to 1 blocking must be configured to avoid Layer 2 loops. For
more information, refer to the discussion on Packet Anomaly protection in the
DefensePro User Guide.
1. Click
Submit
.
2. In the FrameWork Setup pane, to the right of the
Net Nodes
label, click
Add
.
3. In the Add Net Node pane, set the following parameters:
Parameter
Description
Name
NetNode descriptive name.
ID
NetNode ID.
Type (read-only)
Default: Openflow
SDN Node Mode (read-only)
Default: sdnenablednative.
Health Check Interval (read- only)
Default: 60 seconds
4. To the right of the
Protected Links
label, click Add.
5. In the Add Protected Link pane, set the following parameters:
Parameter
Description
Incoming Traffic Port
The incoming traffic port number.
Outgoing Traffic Port
The outgoing traffic port number.
6. Click
OK
.
7. To the right of the AMS Connections label, click
Add
.
8. In the Add AMS Connection pane, set the following parameters:
Parameter
Description
Name
AMS connection descriptive name.
AMS Name
AMS connection name.
NetNode North Port
NetNode NothPort.
NetNode South Port
NetNode South Port.
AMS North Port
AMS North Port.
AMS South Port
AMS South Port.
9. Click
OK
.
10.In the Add Net Node pane, click
Submit
.
FrameWork Maintenance
This section describes how to run maintenance operations on Defense4All
•
Reset to Factory Settings
— If you want to reset Defense4All to its factory settings, at the
bottom of the FrameWork Setup pane, click Reset to Factory Settings.
•
Restart Framework
— To manually restart Defense4All, at the bottom of the FrameWork
Setup pane, click Restart FrameWork.
