6
TROUBLESHOOTING
Tower Stereo will not turn ON.
• Make sure that the power cord is fully inserted in the power outlet.
• Make sure the Power Switch on the back of the unit and the Standby Button on the
top of the unit are both ON.
The remote control does not work.
• Battery is drained. Replace with new battery.
• The front end of the remote control is not aimed at the IR Sensor.
There is no sound.
• Make sure that the audio cable is connected correctly to the back of the Tower
Stereo and the line out jack of your audio device.
• Make sure that the sound system is set to the correct audio input.
• Your Bluetooth device is out of range. Move closer to the Tower Stereo.
• Turn your unit off, then back on.
IMPORTANT INFORMATION
FCC Statement
Warning: Changes or modifications to this unit not expressly approved by the party
responsible for compliance could void the user authority to operate the equipment.
NOTE: This equipment has been tested and found to comply with the limits for Class B digital
device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable
protection against harmful interference in a residential installation. This equipment generates,
uses and can radiate radio frequency energy and, if not installed and used in accordance with
the instructions, may cause harmful interference to radio or television reception, which can be
determined by turning the equipment off and on, the user is encouraged to try to correct the
interference by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and the receiver.
- Connect the equipment into an outlet on a circuit different from that to which the
receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
California Prop 65 Warning
"WARNING" This product contains chemicals known to the State of California to cause birth
defects or other reproductive harm. For more information on these regulations and a list of
chemicals, log on the following website address: http://www.oehha.ca.gov/prop65.html
Industry Canada
This device complies with Industry Canada licence-exempt RSS standard(s). Operation is
subject to the following two conditions: (1) this device may not cause interference, and (2) this
device must accept any interference, including interference that may cause undesired
operation of the device.
This equipment complies with Industry Canada radiation exposure limits set forth
for an uncontrolled environment.
