4
ASSEMBLY
BEFORE YOU BEGIN
WARNING: WHEN INSTALLING THIS GAME,
A 3 PRONG GROUNDED A.C. RECEPTACLE MUST BE
USED. FAILURE TO DO SO COULD RESULT IN
SERIOUS INJURY TO YOURSELF OR OTHERS.
FAILURE TO USE A GROUNDED RECEPTACLE COULD
ALSO CAUSE IMPROPER GAME OPERATION, OR
DAMAGE TO THE ELECTRONICS
DO NOT DEFEAT OR REMOVE THE GROUNDING
PRONG ON THE POWER CORD FOR THE SAME
REASONS AS GIVEN ABOVE. USING AN IMPROPERLY
GROUNDED GAME COULD VOID YOUR WARRANTY.
HAVE A QUALIFIED ELECTRICIAN CHECK YOUR A.C.
RECEPTACLE TO BE SURE THE GROUND IS
FUNCTIONING PROPERLY.
TOOLS NEEDED
Large Allen Key (Supplied)
Phillips head screwdriver
INSTALLATION
Remove the banding from the pallet.
NOTE: BE SURE TO STAND TO THE SIDE WHEN
CUTTING THE BANDS, AS THEY ARE UNDER
PRESSURE, AND COULD SPRING OUT
CAUSING INJURY.
Lift out all cage parts as well as any other parts shipped
along with the game.
Remove the 2 game halves from the pallet.
Set the rear of the game into the approximate location of
where it will be located. If assembling more than 1
game, you must leave space to run the power cords
and linking phone cord.
Set the front cabinet into position in front of the rear
cabinet.
Open the coin and ticket doors and slide the left side cover
forward enough to connect the harnessing from the
rear cabinet to the front cabinet.
Slide the front cabinet into position. Insert the large Allen
key into the holes on the sides of the front cabinet and
rotate the Allen key 180° to lock the cabinet halves
together.
Slide the right hand cover from the game.
Remove the packing material from around the ball release
assembly.
NOTE: KEEP THE PACKING MATERIAL FOR THE BALL
RELEASE ASSEMBLY BEHIND THE GAME IN CASE
YOU DECIDE TO MOVE YOUR GAME LATER.
Open the parts box containing the balls and install them
into the ball return release. (There should be 9 balls
supplied with the game)
Slide the right hand cover back onto the game.
Open the electronics access door. (Door in between the
ticket and coin drawers)
On each Main P.C. Board are 2 modular phone jacks.
Connect a phone line from game to game, plugging 1
end into each game. Feed the phone lines through a
wiring hole located in the rear of the electronic
enclosure. It does not matter which jack you plug the
phone line into on the board as long as the phone lines
are connected from game to game. If you are installing
a Jackpot Marquee, it can be connected to any open
phone jack on any game.
Connect the long Computer style power cord to the Power
Module. The power module is located inside the
Electronics access door, to the lower right. Connect
the other end to a grounded A.C. outlet.*
* Be sure before plugging the game in that it is wired for
the proper A.C. voltage. One way to check is by looking at
the game’s serial number tag. It will indicate the rated
voltage on it. If you are still unsure about what the game’s
voltage is set for, please refer to the “Setting A.C. line
voltages” section in this manual.
Summary of Contents for Ice Ball
Page 17: ...17...
