6
2.
Assembly Procedures
Step 1: Assemble the Supporting Leg Plates
Step 2: Adjust the servo to the central point
Connect the servos, Servo Commander 32 and power lines in the sequences as
illustrated below.
※
While connecting the power supply, please notice that the voltage of this kit should be 6V
(please refer to Notices). It is recommended to use a voltage regulator to ensure that the
voltage is within the safe range.
While installing, please pay
attention that the left and right
leg plates should be
assembled in different
orientations. Each side has
three leg plates.
Screw A
Nut
Power supply input terminals. Please pay attention
to the polarity of the power supply. It is necessary
to connect the “+” terminal to the positive
electrode of the power supply and connect the “-”
terminal to the GND electrode.
Connect all the servos
to Servo Command 32
as shown in the figure.
Please check if the
pins are connected
correctly.
Please check if
the common
power supply is
connected with a
Jumper wire.
