innovaphone IP DECT
Page 29
IP Routes
section:
Static routes for the PPP interface can be configured here. This is required, since
no routing protocol is used.
Local Subs-
criber Num-
ber
The
Local Subscriber Number
, in the case of inbound dial-
up connections, is the call number (MSN) under which inco-
ming calls are to be accepted.
The
Local Subscriber Number
, in the case of outbound
dial-up connections, is the outgoing call number (MSN) to be
used for the call.
2nd Local
Subscriber
Number
If
Multilink
is used, a different call number can be used for
the second channel of the PPP remote terminal being called.
The entry field can be left empty if the same call number as
for the first channel is to be used.
Outbound
Connections
Here, the ISDN interface can be configured for outbound PPP
dial-up connections.
Called Party
Number
The call number (MSN) to be used for the outgoing call.
2nd Called
Party Num-
ber
The call number (MSN) to be used for the outgoing call on the
second B channel.
Inbound
Connections
Here, the ISDN interface can be configured for inbound PPP
dial-up connections.
Calling
Party Num-
ber
By specifying the
Calling Party Number
, the acceptance of
incoming calls can be restricted to this one call number. If the
entry field is left empty, all data calls are accepted on the sel-
ected ISDN interface(s).
Network
Address
The network address of the new route being added.
Network
Mask
The network mask of the new route being added.
Gateway
The network address of the default gateway.
