Setting Stimulation Type, Level, and Tone
Your Command Series 1600E allows the transmitter to
operate two receiver collars. Each of these receivers
may have different stimulation type, level, and tone
from the other receiver collar.
Program your transmitter in just 4 button pushes.
Setting Up the Collar Receiver
Install the battery. With the edge of the supplied wrench or a small coin, unscrew the battery
screw cap. Insert the supplied 3-volt lithium battery with the positive terminal (+) facing out.
Replace and tighten the battery screw cap.
Matching the Transmitter to the Collar Receiver
CAUTION:
Never place the collar on your dog before matching the collar receiver to the transmitter.
1. Hold the red paper dots on the transmitter and collar receiver together.
2. Continue to hold the red paper dots together during the following series of lights on the col-
lar receiver. A solid light will come on and go out followed by another solid light.
3. Separate the transmitter and collar receiver by about 30 cm. A flashing light will be on the
collar receiver.
4. Press Button 1 on the transmitter for 2 seconds. The light on the collar receiver will pulsate
red. Stimulation will be delivered when Button 1 is pressed so do not touch the probes.
5. Release Button 1. The light on the collar receiver will begin blinking green.
Note:
We suggest you synchronize the yellow collar to the yellow column of buttons, blue col-
lar to the blue column, etc.
ENG-7
ENG
A.
Press the round
BLUE
button to
begin program-
ming
B.
Set stimulation
type by pressing
either the:
GREEN
button
(Continuous
stimulation);
YELLOW
(momentary
stimulation) or
RED
(rising stimula-
tion)
C.
Set stimulation
level following
the table on the
previous page;
in the DOG 1 col-
umn, press
either 1, 2, 3,
or 4.
1.
Lowest range
2.
Medium
range
3.
Med./High
range
4.
Highest range
D.
Set tone by
pressing either
the:
GREEN
button
(tone with stimu-
lation);
YELLOW
(no tone with
stimulation) or
RED
(tone with 1.5
second delay
before stimula-
tion)
E.
Programming is
complete.
Repeat the pro-
cedure for the
right-hand DOG
2 column.
ODEL 800
DOG
1
DOG
2
1
2
3
4
1
2
3
4
1
2
3
4
Fig. 3 –
Programming the transmitter
english(eng).qxp 10/27/2005 11:39 AM Page ENG-7