7
T
PMS-4000
8
Power off
Standby Time
4 Warning Conditions
Rapid Leakage
Pressure
Leaking
PSI
Temp
C
Slow Leakage
High Temperature Warnings
Low Pressure Warnings
PSI
Pressure
Leaking
Temp
High Air Pressure Warning
Multi-Warning Indication
Bar
Pressure
PSI
Pressure
InnoTechRV
InnoTechRV
Hold down the middle button for at least 8 seconds, and the monitor will automatically switch
off. Please note: the system will first enter into Programming mode 5 seconds while holding
down the middle button, continue holding down the middle button until the screen goes
completely blank to power off the monitor.
Note: Whether the monitor is turned on or off, the sensors will continue to transmit normally..
The monitor has an intelligent 15 minute Sleep mode. The monitor goes into Sleep mode to
save power after the vehicle has been motionless for more than 15 minutes. When movement
is detected, the monitor automatically turns on and recommences monitoring of the sensors.
The INNOTECHRV TPMS-X has two primary functions, monitoring the temperature and
pressure conditions of the vehicle’s tires. The following are the abnormal conditions that will
trigger a warning.
When the air pressure of a tire drops more than (3psi) within 2 minutes
the monitor will signal an audible alarm and the “Leaking” icon will
flash on the monitor’s screen
When the air pressure of a tire drops more than 3psi over a period of
between 2~10 minutes, the monitor will signal an audible alarm and the
“Leaking” icon will flash on the monitor’s screen. The Wheel position
will flash to indicate which tire has the abnormal air pressure and what
its current air pressure reading is. The red LED will also flash on the
monitor.
Note: If there is a fast or slow leak the sensor will send a message to
the monitor whether driving or stationary.
When the temperature inside the tire exceeds 149oF (65oC)
the system will give a stage 1 high temperature alarm and the
monitor will indicate the position of the tire with the abnormal
temperature along with its current temperature. Abnormal
temperature is indicated by the flashing red LED on the
monitor and the temperature icon flashing on the screen.
A stage 2 alarm will occur if the temperature inside the tire
exceeds 167 oF (75 oC) (See Indicator levels on right)
When the actual tire pressure is equal to or falls below 85% of
the set pressure the system will give an alarm and the
monitor will indicate the position of the tire with the abnormal
air pressure and its current pressure. The low pressure is
indicated by the flashing red LED on the monitor and the
pressure icon flashing on the screen.
Two further Low Pressure Alarms will occur at 75% and 50%
below set pressure respectively. (See indicator levels on
right)
When the actual pressure is equal to or greater than 120% of
the set pressure the system will give an alarm and the
monitor will indicate the position of the tire with the abnormal
air pressure and its current air pressure. The high pressure is
indicated by the flashing red LED on the monitor and the
pressure icon flashing on the screen, as the graphic on the
When there are more that one Warning indications with one
Tire simultaneously, the monitor will indicate all the various
Warning Icons as the graphic on the right shows.
When there are Warning alarms on two or more tires at the
same time, the respective tire icons with the abnormalities
will all flash on the screen. In this situation the current tire
reading being displayed will be indicated by that tire icon
flashing more rapidly than the other icons.
PSI
Pressure
Pressure
Leaking
