SENSOR
2
1
TPMS-4000
TPMS-4000
(MONITOR)
1 Introduction
2 Function
Unit Conversion Formulae
Temperature
F=9C/5+32
C = Celsius; F = Fahrenheit
Pressure
1 Bar=14.5 psi
1 Bar=100 kPa
2
1 Bar=1.02 kgf/cm
Right (R)
button
Left (L)
button
Middle (
SET
)
button
Congratulations on purchasing the new InnoTechRV TPMS-4000-X Tire
Pressure Monitoring System.This system is a safety system for monitoring
the vehicle’s tire pressure and temperature. It consists of externally
mounted wireless sensors, fitted to the vehicles tire valves, and a hand-
held monitor. The sensors monitor the tire air pressures and temperatures
a n d t r a n s m i t t h i s i n f o r m a t i o n t o t h e d a s h m o u n t e d m o n i t o r.
The monitor can be placed on the dashboard, on the sun visor or mounted
i n a n y c o n v e n i e n t p l a c e i n t h e v e h i c l e u s i n g t h e w i n d o w
mount included.
PSI
KPa
Bar
2
Kgf/cm
Pressure
sensor
monitor
Temp
Leaking
TEMPERA TURE CONDITION icon
BATTER Y CONDITION icon
Bar icon
KPa icon
PS I icon
Kgf/cm
2
icon
˚C icon
˚F icon
NUMERICAL
INDICATING
SECTION
MONITOR icon
SENSOR icon
PRESSURE CONDITION icon
LEAKAGE icon
C
F
InnoTechRV
InnoTechRV
The monitor’s function is to receive the temperature and
pressure information transmitted from the sensors fitted
to each tire and display this information on the screen in
the specific units of measurement of your choice.
The monitor will emit an alarm when a tire pressure or
temperature varies markedly from the targeted tire
pressure and/or temperature (refer section 4.) The
system will detect high or low air pressure as well as high
temperature or rapid leakage from the tires. The monitor
will flash a red warning LED lamp and an alarm will sound
to remind the operator to check if the tires are high or low
in air pressure, there is leakage, a high temperature
condition, the monitor’s battery is low, or there is a
problem with a sensor.
Turn the monitor on by pressing the middle button. Turn
off by holding the middle button until the monitor shuts
itself down. Note the monitor will only shut down from
Normal operating mode.
3 Installation & Operating Instructions
The following graphic identifies the icons on the monitor.
Important; before installing the tire sensors:
a. Ensure you have inflated the vehicle’s tires to your required pressures.
Note: It is recommended to set tire pressures at those recommended by the
manufacturer or listed in the vehicle’s handbook,
b. Ensure the monitor battery is fully charged and is in Alignment mode,
c. Ensure batteries have been fitted to each sensor. UNDER the terminal, + side up)
d. If supplied, fit the small foam rubber pad inside the top of the sensor cap
(designed primarily for off road vehicles)
Note: Do not over-tighten the plastic cap as this may damage the cap and o-ring.
TPMS-4000
Fitting Sensor Locks (Optional)
The kit is supplied with security locks
for the sensors. Use of these is
optional. Screw nut onto valve stem
before fitting sensor. Tighten sensor
then tighten lock nut back up to sensor
using wrench supplied.
