To check the unique Serial number of the iTaste SVD2.0:
1) Set the resistance to 5W.
2) Click the power down (-) button 10 times to display the
Serial number.
Reverse Polarity Protection:
The Evolv Experience chipset is protected from damage
caused by reverse polarity. If the battery is inserted properly
the device will not fire and the chip will not become
damaged. Please ensure that you insert the battery in the
correct direction by lining up the positive (+) and negative (-)
ends of the battery correctly.
Reset:
When the battery low quality and voltage very low the
iTaste SVD2.0 will reset.
Technical Specifications:
Input Voltage:
3.2~4.3V
Output Voltage:
2.0~6.3V
Maximum Output Current:
6.0A
Maximum Output Wattage:
5.0-20W
Resistance of clearomizer:
0.5-3.0 ohm (0.5 Ohm minimum)
Battery:
IMR high drain 18350/18650 (without protection,
maximum current > 5000mA.)
The iTaste SVD2.0 cannot use 2 stacked batteries and any
other types of batteries may damage your iTaste SVD2.0.
25-Seconds Cutoff:
If the button is held down for 25 seconds or longer, the iTaste SVD2.0
will automatically power off until the button is released and pressed
again.
Short Circuit/Atomizer Protection (0.5 Ohm):
Short Circuit/Atomizer Protection protects the iTaste SVD2.0
Advanced Personal Vaporizer against shorted atomizers and
will stop the unit from functioning in unsafe conditions.
iTaste SVD2.0 Travel Case and Battery Power level checker.
The iTaste SVD2.0 is packaged with a high quality travel case.
The case can be used to carry your iTaste SVD2.0, 18650 and
18350 batteries, atomizer/clearomizer and build materials.
The case also has a built in battery level power tester. To use
the battery power level tester simply attach each the wired
sensors to the positive (+) and (-) side of the batteries.
We recommend that eliquid not be stored in the case with
your device and batteries to prevent damage.
Battery Installation
Short 18350 tube
Long 18650 tube
EN-5
To use an 18650 battery please attach the long 18650 tube.
To use an 18350 battery please attach the short 18350 tube.
