background image

 

Until the voltage setting is displayed pressing of either the 

V+

   

or 

V-

   

will have NO effect. 

Once voltage is displayed you may adjust the voltage up or down using the

 V+   

or 

V-

   

in 

0.1 V

 steps from 

3.3V

 up to 

5V

.  

The voltage setting do not cycle continuously – once you have reached 5V the only way to 
adjust back down is to use the V- button and vice versa. 

 

NOTE

: After the buttons are pressed or voltage has been adjusted you will not be able to 

operate the power button until the display has closed down – this takes approximately 

1.5 

– 2.0

 

seconds. 

 

CHARGING & PASS THROUGH FUNCTIONALITY. 

Charging of the device can be accomplished by using the supplied charging adapter and 
plugging it into a suitable powered USB port and the corresponding 

MICRO USB

 connector 

on the adapter into the bottom of the device in the 

INPUT

 port. 

The charge adapter consists of a standard USB connection cabled to a 3 way adapter 
comprising a MINI / Micro USB connector and an IPhone connector 

(not suitable for iPhone 5)

 

The unit requires approximately 

3.5

 

to 

5.5

 

hours to fully charge dependant on the 

discharge state of the battery – you are able to use the device whilst it is charging via its 
pass-through functionality.  However it is not a true direct current pass-through and still 
relies upon the battery to deliver working current. 

If the battery is heavily discharged the LED’s will either display red or orange for a short 
time – once the Led displays 

steady green status

 there will be enough charge within the 

battery to allow use of the device during its charging cycle.   

Note however that continual uninterrupted use of the device will essentially negate any 
charging taking place and the device will likely not charge for an extremely long duration 
under this circumstance. 

When the device has been fully charged the Green LED will cease to light up and the device 
may now be disconnected and used as per normal.   

 

http://www.sfumando.it/itaste-mvp/

http://www.sfumando.it/itaste-mvp/

Summary of Contents for itaste mvp








Reviews: