Note
a state of complete discharge need not be achieved before charging can take place –
the unit can be charged when just the orange light displays during operation and charge
time will likewise be considerably shorter as a result.
It is recommended however that even though Lithium Ion Polymer batteries do not suffer
from memory effect -- the occasional complete discharge and lengthy charge is advisable
to keep the internal battery optimised to its fullest.
Also note due to the nature of such battery cells full operating performance may not be
achieved until a few discharge and charge cycles have been accomplished.
3
RD
PARTY DEVICE CHARGING
Due to the high capacity of the device battery – when circumstances require - it can be
used to charge 3
rd
party devices such as mobile phones iPods etc… through use of the
output terminal on the base of the device.
In order to do this you must first slide the
Output ON/OFF
switch to the
ON
position and
this will activate the USB output port – connect a device to be charged into this USB port
and the MVP will commence to charge the device you have attached.
Note – naturally this will severely limit the battery capacity of the device for actual
operation of atomisers as available power is drained for the 3
rd
party device. Hungry
devices a such as IPADS which can pull up to 2.5 amps or more are NOT recommended for
this device – the MVP can output a maximum of 1A which will drain very quickly when
connected to power hungry devices.
Ensure that the device OUTPUT switch is in the OFF position for normal vaping operation.
Note: The device can be charged via standard USB to MICRO USB cables plugged into mains
USB chargers with an output up to 1Amps with no issues.
http://www.sfumando.it/itaste-mvp/
http://www.sfumando.it/itaste-mvp/
