SMART SOCKET SSC100 USER MANUAL
6
If you want check that which mode is the Smart Socket programmed to, disconnect it from the
power socket and then connect back again. The Smart Socket will now emit one, two or three
signals, depending on its mode.
One signal
- Electric appliance fire guard, turning an appliance off for alerting purposes or
water leak guard (an alarm turns off the appliance connected to the Smart Socket).
Two signals
- Additional signalling device (an alarm activates the appliance connected to the
Smart Socket).
Three signals
- Informing a Telecare service of any alarms (transfers information of an alarm).
If you want to change the mode carry out the setup from the section of the desired mode
(sections 3 – 6).
The Smart Socket is not working as it should
Check the Smart Socket’s mode (see section 7). If the Smart Socket was set to a wrong mode
carry out the setup from the section of the desired mode (sections 3 – 6).
16A 230VAC, power consumption <1W, RF 433Mhz.
This device fulfils EU directives’ requirements.
Technical Director Matti Myllymäki
See more detailed description on www.innohome.com/eudeclaration.
This product has a 2 year warranty that covers defects in material or workmanship, starting
from the date of purchase. The warranty does not cover any indirect damage caused by a mal-
functioning appliance, damage caused by negligence, or damage caused by failure to follow
the instructions properly.
7. Checking the mode
8. Troubleshooting
10. Warranty
9. Technical Information and EU Declaration of Conformity
