1.8” SATA SSD 3SE
16
Rev. 1.1 TPS, Jan. 2015
4. Installation Requirements
4.1 1.8” SATA SSD 3SE Pin Definition
Figure 3: Signal Segment and Power Segment
4.2 Electrical Connections for 1.8” SATA SSD 3SE
A Serial ATA device can be connected to a host system through a cable. The cable should not be
longer than one meter. The SATA interface also has a separate connector for the power supply.
Please refer to the pin description on Table 8 for further details.
4.3 Form Factor
Please turn off your computer, and open your computer’s case. Find one of available 1.8-inch slot,
and connect the 1.8” SATA SSD with your computer or connect the SATA data cable, and power
cable from your power supply. Please boot the installation Operation System from CD-ROM, and
install Operation System into SSD.
4.4 Device Driver
No additional device drivers are required. Innodisk 1.8” SATA SSD 3SE can be configured as a
boot device or storage device.
