2.5” SATA SSD 3MR2-P
36
Rev 1.0 TPS, Apr., 2017
4.2 Electrical Connections for 2.5” SATA SSD 3MR2-P
A Serial ATA device may be either directly connected to a host or connected to a host through a
cable. For connection via cable, the cable should be no longer than 1meter. The SATA interface has
a separate connector for the power supply. Please refer to the pin description for further details.
4.3 Form Factor
Please prepare following things:
Screw driver.
Four M3 screws.
SATA single cable (7-pin, Maximum length l meter).
SATA power cable (15-pin).
Please turn off your computer, and open your computer’s case. Find one of available 2.5-inch slot,
and plug the SSD in. To use the screws fix the SSD. Plug in the SATA single cable, and power cable.
Please boot the installation Operation System from CD-ROM, and install Operation System into
SSD.
Figure 4: 2.5” SATA SSD 3MR2-P Mechanical Screw Hole
4.4 Device Drive
No additional device drives are required. Innodisk 2.5” SATA SSD 3MR2-P can be configured as a
boot device.
