54
INNOCIGS EGRIP 2 LIGHT – CHANGING & OPERATING OF MODES
2. Installing new atomizer coils
If an atomizer coil is replaced with one which has a greater resistance than the previous one, it is important
to reset the “Base Resistance“ of the atomizer. This is the resistance of the coil at room temperature. Initiate
a reset by pressing the fire button of the eGrip 2 Light while the clearomizer and base are not attached. After
connecting the clearomizers base with a new head, “New Coil Up, Coil Same Down“ will appear on the display.
Confirm that a new coil has been installed by pressing the “up“ button.
If you see this message in other instances - especially when you reinstall the same coil which is still warm
from recent use - press the down button, so that the “base resistance“ is not reset.
Always remember to adjust the operating mode of the coil used to ensure proper temperature control.
b) Before changing to another atomizer coil, unlock the resistance. Otherwise, the VT system will not work properly. In “Resistance
Unlock“ mode, please make sure that the coil is changed at room temperature to ensure temperature accuracy.
