Square Bolt
Mounting Hole
Specification Sticker
1
4
5572546A
1
3
2
5
7
9
4
6
8
10
3
2
5
①
②
③
1
2
3
4
5
6
2
4
4
4
4
4
4
Carrier Main Body
Square Bolt (Short)
Square Bolt (Long)
Long Nut
Spring Washer
Spacer
Flat Washer
7
8
9
1
2
1
1
Hex Wrench
Key
Installation Instructions
Installation Instructions
10
11 Specification Sticker
11
Affix the specification sticker
in the relevant language
on the stay.
Spacer
Cover
Square Bolt
Attach mounting clamps
Check enclosed parts
- 1 -
EN
Mountable bar
Prepare to install the crossbars
This product can be attached not only to the INNO aero bar but also to
the factory crossbar whose T slot fits the dimensions below.
Check vehicle or carrier base product
instructions to confirm that the carrier
base to which this product is to be
installed has sufficient strength to
support this product. If the carrier
base does not have sufficient
strength to support this product, do
not install.
It cannot be mounted on the stay
cover.
H : 5mm 〜
W : 21 〜 22mm
A : 10.5 〜 11.5mm
Height of this product is adjustable in accordance with the load.
Product comes packed in the high position.To change to the low
position, pull the spacer straight down to remove.Be sure to mount
product at the same height on both the left and right sides.
High Position
Low Position
XA927 928
A
Mounting Holes for Square Bolts
Thank you for purchasing this inno product.
Read instruction thoroughly before use for correct usage.
Keep this manual in a safe place to avoid being lost.
Check strength of the crossbar before mounting the carrying system.
Do not install this carrying system to a Crossbar of strength poverty.
The distance between the front and rear crossbar should be at least 24 inch (600 mm).
Make sure that all bolts and nuts are securely tighten before driving.
Do not exceed a speed of 80 mph (130 km/h) when carrying ski or snowboard. And
observe legal speed limit. When the bindings do not fit between the front and rear
crossbars, it is recommended not to exceed the speed limit over 50 mph (80 km/h).
Always lock and secure the carrier with a key before driving.
The lock on this rack is not guaranteed to prevent theft.
Falling of carrier parts or loads may cause potentially serious accidents
involving vehicles and individuals following behind result in severe injury or
death.
May cause injury to individuals or damage to the product, vehicle and loads
being carried.
Caution
Caution
Attention
Parts
Q'ty
No.
Parts
Q'ty
No.
The distance between the front and rear crossbar should be at least
24 inch (600 mm).
Widen the crossbar as need until both binding fit between them.
Binding
Rear carrier / Crossbar
Front carrier / Crossbar
Recommendation 29 ½ inch (750 mm)
At least 24 inch (600 mm)
Insert the key and turn
left to unlock.
While pressing the button, lift the
upper arm up to open.
Unlock
Lock
Button
Upper Arm
①
②
③
If the cover is attached, remove to allow insertion into T slot on the bar.
Set the square bolt to the T slot.Use the square bolt (long) for high position and the square bolt (short) for low position.
Insert the square bolt into the mounting hole of the carrier main body to set temporarily.
Mount carrier on car
・
