InMotion 35-1625E, Owner'S Manual

Page: 8 / 19

ASSEMBLY INSTRUCTIONS
8
ALWAYS USE TWO OR MORE STRONG PEOPLE TO UNFOLD OR FOLD THE
INMOTION FOLDING TRAMPOLINE. FAILURE TO USE TWO OR MORE STRONG
PEOPLE MAY ALLOW THE RAILS TO SPRING BACK INTO THE FOLDED
POSITION AND STRIKE SOMEONE WHICH CAN CAUSE SERIOUS BODILY
INJURY OR DEATH.
Keep fingers away from the ends of the rails in the hinge area when unfolding the inMotion
Folding Trampoline. Serious injury can occur if fingers are caught between the ends of
STOP!
Hold RAILS(3, 4) and push down on RAILS(1, 2) to unfold the inMotion Folding Trampoline to the flat
position. The RAILS(1, 4) and RAILS(2, 3) should snap together and be locked by the SECURE PINS(10)
when you reach the flat position. Refer to illustration 2.
STEP 2
NOTE: Make sure the SECURE PINS(10) are inserted into the ends of RAILS(1, 2) and properly secured
by the Wire Ring. Both ends of the SECURE PINS(10) should have approximately 1/8 inch between
the RAILS(1, 2) and the Wire Ring. Refer to illustration 2.
2. 3.
A.
First step,
install the Safety Pad(6) on
to this Threaded Connector.
B.
Second Step,
install the Safety
Pad(6) on to
this Threaded
Connector.
Hazard label on trampoline surface reads as follows:
! WARNING!
PREVENT serious INJURY or DEATH.
Rails can SPRING back and STRIKE someone.
ALWAYS fold and unfold carefully with TWO or
more STRONG people.
Do NOT remove this tag.
!
WARNING
STEP 3
Slide the
SAFETY PAD(6)
over the rail frame. Make sure the holes in
SAFETY PAD(6)
fit over the threaded
connectors properly. Refer to illustration 3.
HINT : Install one hole over a threaded connector. The next hole installed should be on the connector on
the opposite side of the trampoline.
4.
Warning
Label
Warning
Label
STEP 4
Remove the Plastic Caps from the threaded
connectors. The two LEGS(7) with a Warning
Label must be on opposite sides of the inMotion
Folding Trampoline. Screw one of the LEGS(7)
with a Warning Label onto a threaded connector
on the rail frame. Attach the other LEG(7) with a
Warning Label to the threaded connector directly
opposite the other LEG(7) with a Warning Label.
Screw the other four LEGS(7) onto the threaded
connectors on the rail frame.
Remove all of
the six Plastic
Caps from the
threaded
connectors before
installing the LEGS(7).