Inmes FF-325 PLUS, Operation Manual

Page: 14 / 62

INMES Industrial Ltda – Sliding table saw FF-325 Plus 12
4.2 Loading and unloading equipment (Fig. 4.2)
When loading and unloading this equipment, avoid
mechanical shocks to prevent damage to persons and the
machine itself. Make sure no one is wrapped around the
equipment used to move the machine while it is being moved.
This machine should be lifted by a crane or forklift. Before
you begin handling the equipment to its correct location,
remove any parts that were used for shipping or packing that
are still in the machine. Check that the carrying equipment
capacity is adequate for the indicated machine weight Pic.4.2
If transporting by forklift proceed as follows:
Adjust fork width A to 500mm
- Insert the forks A as shown in the figure corresponding to
the nameplate E making sure that the forks are aligned with
the back of the rear feet D of the machine.
If a crane is available, proceed as follows:
- Provide two B-belts of sufficient length and capacity
(minimum belt length must be 4 meters).
- Raise the belts and position them as shown in Fig. 4.2.
- Adjust the belts at the tip of crane C with the force required
to lift the machine.
- Move the crane slowly so that the belts adjust until the
machine can be stable.
- Carefully lift the crane slowly without the equipment
swinging, after which move the machine to its proper place.
- Remove all protective grease from unpainted tables and
surfaces using kerosene or by-products. Do not use solvents,
petroleum or gas oil, which may damage the paint or rust
parts of the machine.
This equipment should only be transported by persons
specially trained to perform this type of operation.
(Pic. 4.2)
703
kg