9
©2000 - INLINE, Inc.
IN2013HR Operation Manual - V1.0 12/05/00
SWITCH 2 (MONITOR EMULATION)
The IN2013HR includes a bank of 10 dipswitches (SWITCH 2) on the bottom side of the interface for
monitor emulation. Setting the dipswitches to the appropriate positions allows the unit to emulate the
appropriate sense signals, thus setting the video card to the desired frequency, refresh rate and resolution,
even without a local monitor. When configured properly, the interface can emulate virtually any type of
monitor.
Using the IN2013HR with a Local Monitor
Many high-resolution graphic workstations use sense signals to set resolution, horizontal frequency and
vertical refresh rate. The IN2013HR passes all sense pins between the computer video port and the Local
Monitor, ensuring that the computer can sense the attached monitor and set itself to an appropriate
resolution and scan rate for that device. The Monitor Emulation dipswitches must all be set to “0”
when using a local monitor. This allows all sense pins to pass through, ensuring proper operation of
the graphics card and monitor.
Using the IN2013HR without a Local Monitor - The IN2013HR’s design makes it easy to use the
interface without a local monitor. Because the Local Monitor Output port is buffered, there is no need for a
termination plug to terminate the video signals when used without a local display device. If you are not
using a local monitor, but need to emulate a specific mode, locate your workstation type and desired mode
in the chart at the bottom of the page. If you are not sure of the exact mode to select for your computer,
select the setting shown in bold since it is the most common mode. Using the IN9339 Alignment Tool
(provided), gently set the dipswitches to the appropriate settings.
Check the Monitor Emulation chart and the IN2013HR dipswitch settings
carefully. An improper setting of the emulation dipswitches may lead to
improper operation and could even result in severe damage to the computer
video port or the monitor. Some modes listed on the following page may not be
supported by certain workstations / graphics cards.
Monitor Emulation Dipswitch Chart
Make / Model
Dipswitch Settings
SUN
1152x900 / 66 Hz / 61.8 KHz
0011000000
1152x900 / 76 Hz / 71.7 KHz - 16” / 17” Monitor
1001000000
1152x900 / 76 Hz / 71.7 KHz - 19” Monitor
1001000100
1280x1024 / 76 KHz / 81 KHz
1011000000
1600x1280 / 76 Hz / 100.8 KHz
0011000100
SGI
Single Scan 15” (Indy) 1024x768 / 60 Hz / 48.48 KHz
0100000000 or
0100000010
Single Scan 19” (Personal Iris / 4D) 1280x1024 / 60 Hz / 63.9 KHz
0000000000
Hitachi 19” 1280x1024 / 60 Hz
0100011000
Dual Scan 16” (Original Indigo) 1280x1024 & 1024x768 / 60 Hz / 63.9 &
48.48 KHz
0000010000
Dual Scan 19” (Original Indigo) 1280x1024 & 1024x768 / 60 Hz / 63.9 &
48.48 KHz
0100010000
Multiscan 16” Up to 1280x1024 / 76 Hz / 30 - 82 KHz
0100001000 or
0100001010
Multiscan 19” Up to 1280x1024 / 76 Hz / 30 - 82 KHz
0000011000 or
0000011010
Multiscan 21” Up to 1280x1024 / 76 Hz / 30 - 82 KHz
0000001000
