12
Maintenance instructions
Lubrication
Use the oil
that were supplied with the machine and follow these steps to lubricate every
100 hours of use. Only use the oil provided with the machine, other oils may reduce lifetime
of the machine and / or clog.
1.
Remove grip and needle.
2.
Remove the cap
and use the Releaser
to release the Piston assembly
while pushing the Piston assembly
down to the bottom of its stroke. Lube with a
small amount of oil in the corners between the piston and the frame
. Put the cap
back in place by pushing and moving it in a circular motion.
3.
Apply oil just above the needle bar pin in the oval hole.
4.
Apply oil on the bearings
of the Needle bar retainer
and roll the bearings a
few times back and forward to let the oil run into the bearings.
5.
Apply oil between the Bearing rod
and the Shaft support
. No oil is required
on the cam or the cam bearings.
6.
Run the machine around 9 volts for about a minute and clean it when done.
Releaser