06 TROUBLESHOOTING GUIDE
27
What can you do if the programmed system or the manual mode is not
working? Here are some possible reasons and relative solutions for
reference. We hope they are helpful. For any further questions, please
feel free to contact INKBIRD.
Q: The water supply is not available?
A: Please confirm if the water main is connected and if all water pipes
are open and work normally.
Q: Lines are loose or incorrectly connected?
A: Please confirm if the ground line and the main valve, or the triac, are
steadily connected to the controller, and firmly linked on the scene.
Q: Electrical wires on the scene are corroded or damaged?
A: Please install a replacement wire if the original one is damaged. You
can install a waterproof connector if needed.
Q: The rain sensor in connection being activated?
A: Please dry out the rain sensor or disconnect it to the terminal of the
controller, and then connect 2 SENS ports using the jumper.
Q: The jumper on the terminal that linked S and 24- ports is missing
or damaged?
A: Please replace it with any conductive wire.
