Page 4 EVO7006
13.
Place the 5.00” hump hose and
two #80 clamps onto the Injen intake
plenum on the injen air box.
15.
Place both MAF sensors onto their
appropriate location and then screw them
down with the supplied M4 bolts. Recon-
nect the MAF sensor harnesses
14.
First slide the big end of the intake
pipe into the 5.0” hump hose on the air box
plenum. Then slip the smaller end into the
4.25”-4.50” step hose on the turbo inlet.
Once intake is adjusted, tighten all clamps.
Hump hose
1.
Upon completion of the installation, reconnect the negative battery terminal before you start the engine.
2.
Align the entire intake system for the best possible fit. Once the intake has been properly fitted continue to tighten all nuts, bolts and clamps.
3.
Periodically, recheck the alignment of the intake system and make sure there is proper clearance around and along the length of the intake. Failure to follow proper
mainentance procedures may cause damage to the intake and will void the warranty.
4.
Start the engine and listen carefully for any odd noises, rattles and/or air leaks prior to taking it for a test drive. If any problems arise go back and check the vacuum lines,
hoses and clamps that maybe causing leaks or rattles and correct the problem.
5.
Check the filter for excessive dirt build up.
Enjoy the added power and performance of your new intake system.
Congratulations! You have just completed
the installation of this intake system. Period-
ically, check the alignment of the intake, nor-
mal wear and tear can cause nuts and bolts
to come loose.
Note: Check clearance and
adjust if needed! Failure to check the
alignment and adjust the intake can
cause damage that will void the warranty.
Injen Technology is not responsible for
any damages caused by/from improper
installation.
Instruction Manual
P/N:EVO7006
Test Drive:
1.
With the transmission in neutral or park and the parking brake engaged, start the engine. Listen for air leaks or odd noises. If air leaks are detected, secure hoses and con-
nections. For any odd noises, inspect entire system for cause and adjust intake as needed. The Injen intake will function identically to the factory system but will be louder and
more powerful.
2.
Perform a road test. Listen for odd noises or rattles and fix as necessary.
3.
If there are no issues, continue to enjoy your added performance from the Injen performance Intake kit.
4.
Injen Technology recommends you periodically check clearance and adjust if needed! Failure to check the alignment and adjust the intake can cause damage that will
void the warranty. Injen Technology is not responsible for any damages caused by/from improper installation.
1st.
2nd.
