Page 3 EVO7006
1.
Stock intake system shown.
3.
Remove the factory the two maf sen-
sors from the factory air box assembly.
4.
Firmly lift up on the stock air box as-
sembly and pull the stock air box assem-
bly out of the engine bay.
2.
Disconnect the MAF sensor harness.
Loosen the clamp on the intake duct and
then remove entire air duct
5.
Place the grommet onto the drilled
hole on top of the Injen air box. Connect
the vacuum line to the filter minder then
run the Filter minder into the grommet.
8.
Place the three M6X25mm bolts and
one M6X80mm into the plenum illustrated
by the photo. Your Injen air box assembly
is now complete.
7.
Connect the 3mm vacuum hose
from figure 6 to the barbed fitting on the fil-
ter
6.
Place the filter onto the the Injen in-
take plenum and then secure the clamp.
9.
Remove the 10mm bolt from the
support bracket and then swing the support
bracket towards the right. This will allow
you to install the Injen air box.
12.
Place the 4.25”-4.50” step hose
and two #72 clamps onto the turbo inlet.
Tighten the clamp on the turbo inlet side for
now.
11.
Lower the Injen air box into the en-
gine bay. Make sure the pegs under the
Injen air box goes into the factory air box
grommets on the air box tray from figure 10.
Also re-install the support bracket.
Grommet
Filter minder
Instruction Manual
P/N:EVO7006
M3X25MM
M3X80MM
Loosen clamp
Loosen clamp disconnect harness
Vacuum line
10.
The factory air box assembly
bracket is shown in the photo. Arrows indi-
cate the grommets where the Injen air box
mounts will go.
Remove 10mm bolt
