1. Upon completion of the installation, reconnect the negative battery terminal before you start the engine.
2. Align the entire intake system for the best possible fit. Once the intake has been properly fitted continue
to tighten all nuts, bolts and clamps.
3. Periodically, recheck the alignment of the intake system and make sure there is proper clearance around
and along the length of the intake. Failure to follow proper mainentance procedures may cause
damage to the intake and will void the warranty.
4. Start the engine and listen carefully for any odd noises, rattles and/or air leaks prior to taking it for a test
drive. If any problems arise go back and check the vacuum lines, hoses and clamps that maybe causing
leaks or rattles and correct the problem.
5. Check the filter for excessive dirt build up. Clean or replace the filter with an original Injen filter (can be
bought on-line at “injenonline.com”). Congratulations! You have just completed the installation of the best
intake system sold on the market. Enjoy the added power and performance of your new intake system.
The MAFS is pressed into the adapter and secured
with the stock screws(A). Can be converted into a
short ram as shown above, simply press the air filter
over the end of the primary intake and tighten the fil-
ter clamp(B).
Press the supplied 12” vinyl trim around the resonator
opening(A). This will prevent any damage to the second-
ary air intake system. Press the 3” straight hose over the
primary intake and use two .362 power-bands, tighten
the clamp over the primary intake at this point (B).
The secondary intake system is inserted through the bumper area. Carefully
insert intake into the resonator opening and into the engine compartment (A).
Once you’ve slipped the intake into the engine compartment, press the top end
into the hose on the primary intake. Align the intake bracket to the vibra-mount
stud and use the fender washer and flange nut to secure the intake (B).
The primary and secondary intakes are joined together and fastened with the
Power- bands provided.
Check fitment for best possbile fit then continue to
tighten all clamps .
Page 4 of part# SP2115
Congratulations! You have just completed the installation of the best intake
systems on the market. Periodically, check the fitment of the entire intake
system for possible shifting or misalignment, failure to do so could void theintake
warranty .
The filter is placed on the end of the secondary intake and the filter clamp is
tightened neck is fastened to secure the filter in place. Once proper clearance
has been made through out the length of the intake, continue to tighten all nuts,
bolts and clamps, then check for any possible vacuum leaks.
Once you have installed the mass air flow sensor,
the stock screws are used to secure the sensor in
the machined adapter (A). Press the electical har-
ness clip over the mass air flow sensor until you
hear it snap in into position (B).
(B)
(A)
(A)
(B)
(A)
(B)
(A)
(B)
Figure 31
Figure 30
Figure 29
Figure 28
Figure 27
Figure 33
Figure 32
