Replace the top air box to the lower air box and pop
the metal clips to the top box. Now, pull the entire
air box cleaner and air intake duct from the engine
compartment..
To make the installation easier, you may want tore-
move the entire front bumper. Removing all bolts
and plastic clips holding the bumper in place and
gently pull the front bumper off.
Pop the two metal clips off the lower box
hooks and separate the air box top from
the air box bottom.
Loosen and remove all three bolts from the lower air box
cleaner.
Remove the air resenator duct located in the
fender well , not shown in this picture.
Use a pair pliers to compress the wings on the tension
clamp on the crank case breather hose. Pull the
clamp back and the breather hose off the air intake
port as shown above.
Using a pair of pliers, compress the wings on the
metal tension clamp and gently pull the air intake duct
off the throttle body .
Remove the engine cover that is secured by two
6mm acorn nuts.
Pull the entire vacuum switching valve from the
rubber saddle on the air intake duct used to secure
the vacuum switching valve.
Page 2 of part# SP2115
Disconnect the mass air flow sensor electrical har-
ness from the sensor.
Remove the vacuum hose from the rubber C-clamp
used to secure the entire vacuum hose on the air
duct.
Loosen and remove the two screws on the mass air
flow sensor (A). Gently, pull the mass air flow sensor
up and out of the sensor housing (B), to be used
later in the instruction.
With the metal tension clamp removed from the throt-
tle body and the two metal clips removed from the
upper air box, continue to pull the top air box off (A).
Now, remove the air filter panel from the lower air box
cleaner (B).
(A)
Figure 3
Figure 8
Figure 7
Figure 6
Figure 5
Figure 4
Figure 11
Figure 10
Figure 9
(B)
(A)
(B)
Figure 14
Figure 13
Figure 12
