Figure 2
Figure 2
Figure 3
Figure 3
Figure 4
Figure 4
Figure 5
Figure 5
Figure 7
Figure 7
Figure 8
Figure 8
Figure 9
Figure 9
Once the mass air flow sensor has been fastened reconnect the harness clip
to the sensor until you hear it snap.
Screw the vibra-mount into the bracket located on the side frame.
Note: The bumper will have to be removed in order to install
the vibra-mount and secondary intake.
Insert the mass air flow sensor into the machined adapter on the intake and
locate in place (A). Use the two supplied M4 bolts to fasten the sensor into the
machined adapter (B). Use a 2.5mm allen driver to tighen the M4 bolts to the
MAF (C)
Take the 2 inch-10mm coupler and press it over the air temperature sensor (A).
Press the coupler with the air temperature sensor over the 1/2” port on the
intake (B).
Insert the primary intake into the engine compartment and insert the top end
into the 2 3/4” hose on the throttle body. Semi-tighten the clamp on the intake
side just to hold it place.
Line up the solenoid with the locating pre-drilled tab to the bracket located on
the intake. Use the m6 x m16 bolt and flange nut to fasten the solenoid to the
bracket (B). Some models may not have this solenoid. If your vehicle is not
equipped with this solenoid, please skip to figure 6
Press the 2 3/4” straight hose over the throttle body. Use two clamps on the
2 3/4” hose but only tighten the clamp on the throttle body.
Slip the remaining 2 3/4” straight hose over the end of the Primary intake. The
side opposite of the machined adapter and vacuum port is the end where the
hose will be placed, use a clamp to fasten the hose to the intake.
(A)
(A)
(B)
(B)
(A)
(A)
(C)
(C)
(A)
(A)
(B)
(B)
(B)
(B)
Figure 6
Figure 6
