Screw the 8mm vibra-mount into the wheel well
mounting location until the vibra-mount is sitting snug
and flush over the mounting point.
Press the 3” straight hose over the throttle body.
Once the hose has been fitted over the throttle body,
continue to use two power bands over the hose and
tighten the band located over the throttle body.
Loosen and remove the two m8 bolts that secures the
resonator box to the fender well.
align the m8 vibra-mount to the pre-tapped hole located
over the wheel well. It may be necessary to use a
punch to drive a hole through the plastic liner under-
neath when installing the m8 vibra-mount.
Once the cover has been removed, continue to dis-
connect the 4mm vacuum line located behind the air
box cleaner.
Unscrew the two screws from the mass air flow
sensor, continue to remove the mass air flow sensor
from the air box cleaner.
Loosen the two flange nuts on the engine cover (A), then continue to remove the
engine cover off from the intake manifold. Unbolt the m6 bolt located on the
grommet below the air box cleaner (B).
Unbolt the second m6 bolt located on the top of the air box cleaner as shown
above. Removing these two bolt shown in figures one and two will allow you to
remove the entire air box cleaner.
Page 2 of Part# PF2057
The entire air box cleaner and resonator box is now
ready to be removed from the engine compartment.
Remove the short 4mm stock vacuum hose from the
fuel pressure regulator. Press the new 18 inch, 4mm
vacuum line over the fuel pressure regulator port.
(A)
(B)
Unplug the crank case breather hose from the air
box cleaner port as shown above.
>>>>>>
>>>>
>>>>
>>>>
Figure 2
Figure 3
Figure 6
Figure 5
Figure 4
Figure 9
Figure 8
Figure 7
Figure 12
Figure 11
Figure 10
