Part number PF2057
2006 Toyota FJ 4.0L V6
1
-
MR Tech Power-flow Intake system
1
-
8” Inverted top power filter
(#1022)
1
- Power Box-
contents:
PB400P-8
1- Powerbox skin plate (A) (#6043)
1- Stabilizer top (B) (#6041)
1- Connecting bottom base (C) (#6042)
1- Top panel pre-filter screen (D) (#6044)
1- 4” velocity stack inlet (E) (#6045)
1- Rect. front pre-filter screen (F) (#6046)
2- main body halfs. (G) (#6048)
4- m6 x 45mm socket head (H) (#6052)
4- m6 x 65mm socket head (I) (#6055)
4- m6 x 12mm socket head (J) (#6056)
1- Power-Box mounting bracket (K) (#20079)
1- 4” straight hose (#3129)
1- 3” straight hose (#3044)
1- 18”- 4mm heater hose (#3104)
2- large Power-Band .462
(.064)
(#4006)
2- Power-Band .362
(.048)
(#4004)
1- 8mm Vibra- mount (#6062)
1- 8mm flange nut (#6017)
1- 5 page instruction
Note: All parts and accessories are sold
on-line at:
“injenonline.com”
Congratulations! You have just purchased the best engineered,
dyno-proven Power-Flow air intake system available.
Please check the contents of this box immediately.
Report any defective or missing parts to the Authorized Injen
Technology dealer you purchased this product from.
Before installing any parts of this system, please read the instructions
thoroughly. If you have any questions regarding installation please
contact the dealer you purchased this product from.
Installation DOES require some mechanical skills. A qualified
mechanic is always recommended.
*Do not attempt to install the intake system while the engine is hot.
The installation may require removal of radiator fluid line that may
be hot.
Injen Technology offers a limited lifetime warranty to the original
purchaser against defects in materials and workmanship. Warranty
claims must be handled through the dealer from which the item was
purchased.
Injen Technology 285 Pioneer Place Pomona, CA 91768 USA
Please check the contents of this box immediately.
Note: This intake system was Dyno-tested with an Injen filter and
Injen parts. The use of any other filter or part will void the
warranty and CARB exemption number.
Parts and accessories
are available on line at “Injenonline.com
Note: The installation of this cold air intake does require mechanical skills. Removal of the front bumper requires
loosening and removing several plastic plugs and screws that may be difficult. It is recommended that this
system be installed by a professional mechanic. Be sure to disconnect the negative terminal before proceeding.
Congratulations! You have just purchased the worlds first tuned intake system.
MR
Technology, Leading the way!
Patent pending
#1022
(A) and (G)
(B)
(D)
(K)
(E)
Power-Box contents:
POWER-FLOW:
An air intake evolution
Tools required:
1- 8mm socket
1- 10mm socket
1- 12mm socket
1- Phillips screw driver
1- 8mm nut driver
1- 55mm allen wrench
1- Disc grinder or Dremel
(C)
(F)
(I)
(H)
(J)
Figure 1
