Installation and programming manual
Settings
39
8.9.2
Send event-triggered voice message
(SmartLogos60 required)
Figure 14 - Events table - Voice messages
You can send one or more voice messages to a specific contact number, for
example, to warn the recipient that intrusion is occurring is underway.
To allow this, the voice messages must be set up as per the instructions in
paragraph
8.5.2 Setting up the voice dialer messages (SmartLogos60 board
required)
. In this way, the description of the message to send will appear in
the message list.
Parameter
Description
Note
Voice dialer
Folder containing 'send voice
message' parameters. Double click
to open: columns containing the
successive parameters will appear.
Double click to close.
=no parameter has
been set
=some parameters
have been set.
Voice
messages
Check boxes corresponding to the
voice messages defined in the Voice
message table. The message
description appears when you mouse
over the respective number on the
tooltip bar. You can select several
voice messages to be played one
after another. For example, you can
record a single "address" message to
be added to all the event messages.
Phone
numbers
Check boxes corresponding to the
phone numbers for outgoing calls set
up in the
Phonebook
. The phone
number description appears when
you mouse over the respective
number on the tooltip bar.
See the
Call all voice
numbers
option to
choose whether the
message must reach only
one of the dialed phone
numbers or all of them
successfully.
