Installation and programming manual
Programming and maintenance from the panel
27
Chapter 10
Programming and maintenance from the panel
Access to the programming and maintenance sections is allowed only when the PROG jumper is inserted:
1. Remove the frontplate
2. Insert the PROG jumper.
3. The Main menu provides the “
Maintenance
” and “
Programming
”
sections.
4. The power supply station is not active. No fault will be signaled.
10.1
Programming operations
From station:
Ok, Programming, Ok
This sequence will access the programming menu.
10.1.1 Setting up the Booster parameters
From station:
Ok, Programming, Ok, Booster,
Ok
This section will allow you to setup the parameters relating to output channel control.
At default all the outputs are set as “Standby-ON” with an undefined activation time (“--m --s”).
10.1.2 Power supply unit options
From station:
Ok, Programming, Ok, Options,
Ok
Navigate through the programming field and set the new values.
Standby
status
This programming field will allow you to select the standby status of the output (24V or 0V).
Press
Ok
to select the activation method, then press
Esc
to save the setting and exit.
Standby-
ON
When the output is in standby status (refer to the table in
paragraph 4.1 Controlling
the Outputs
) it will be at 24V (activation value = 0V).
Standby-
OFF
When the output is in standby status (refer to the table in
paragraph 4.1 Controlling
the Outputs
) it will be at 0V (activation value = 24V).
Activation
Time.
Using keys
S
and
T
this programming field will allow you to select an output and define its
activation time (duration).
The maximum time is 20 minutes. You can increase the value in steps of 5 seconds using the
Ok
key. Press
Esc
to save the setting and exit.
Note:
The PROG jumper must be inserted during the entire programming phase.
Mains
failure
delay
(Delay
mainsFail.)
This is a programmable delay (0 to 30 minutes) which runs between the start of the mains failure
event and the actual fault signal. This delay avoids unnecessary signaling of brief 'Mains failure'
events.
Default setting 2 minutes.
Use the
Ok
key to increase this value.
Esc
to confirm.
Format
You can choose the screen date format. Using keys
S
and
T
, select the desired format then press
Ok
to save the setting and exit.
At default the format is dd/mm/yy.
Language
This programming field will allow you to select the desired language. The screen will appear
automatically on first startup, that is, if the language has not already been selected.
Using keys
S
and
T
, .select the desired language the press
Ok
to save the setting and exit.
L ED te st
R ese t sta ti on
M ain te nan ce
P rog ra mmi ng
