6
4-wire receptacle (14-30R)
Do not use an extension cord.
N
If using a replacement power supply cord, it is recommended that
you use Power Supply Cord Replacement Part Number 3394208.
For further information, please reference the “Assistance or
Service” section of the “Dryer User Instructions.”
G
R
O
UN
D
IN
G
IN
S
T
R
UC
T
IO
N
S
S
A V
E T
HES
E IN
S
T
R
UC
T
IO
N
S
"
"
!!
"
"!
"
!
WARNING:
!
"!"
"" !
"!
"
ELECTRIC DRYER POWER HOOKUP - CANADA ONLY
Electrical Requirements
WARNIN
G
Electrical Shock Hazard
Plug into a grounded 4 prong outlet.
Failure to do so can result in death or electrical shock.
It is your responsibility:
To contact a qualified electrical installer.
N
To be sure that the electrical connection is adequate
N
and in conformance with the Canadian Electrical Code,
C22.1-latest edition and all local codes. A copy of the
above codes standard may be obtained from: Canadian
Standards Association, 178 Rexdale Blvd., Toronto, ON
M9W 1R3 CANADA.
To supply the required 4 wire, single phase, 120/240 volt,
N
60 Hz., AC only electrical supply on a separate 30-amp
circuit, fused on both sides of the line. A time-delay fuse or
circuit breaker is recommended. Connect to an individual
branch circuit.
This dryer is equipped with a CSA International Certified
N
Power Cord intended to be plugged into a standard 14-30R
wall receptacle. The cord is 5 ft. (1.52 m) in length. Be sure
wall receptacle is within reach of dryer’s final location.
INSTALL LEVELING LEGS
WARNING
Excessive Weight Hazard
Use two or more people to move and install dryer.
Failure to do so can result in back or other injury.
1.
To avoid damaging the floor, use a large flat piece of
cardboard from the dryer carton. Place cardboard under the
entire back edge of the dryer. See illustration.
2.
Firmly grasp the body of the dryer (not the console panel).
Gently lay the dryer on the cardboard. See illustration.
3.
Examine the leveling legs. Find the diamond marking.
4.
Screw the legs into the leg holes by hand. Use a wrench to
finish turning the legs until the diamond marking is no longer
visible.
5.
Place a carton corner post under each of the 2 dryer back
corners. Stand the dryer up. Slide the dryer on the corner
posts until it is close to its final location. Leave enough room
to connect the exhaust vent.
6.
Once connection is made and dryer is in final location,
remove corner posts and cardboard.
For mobile home use
Gas dryers must be securely fastened to the floor.
Mobile home installations require a Mobile Home Installation
Hold-down Kit. For ordering information please reference the
“Dryer User Instructions.”
