INGICS
TECHNOLOGY
Parameters
In iBS03, there are two parameters that can be configured.
a. TX power: High(+5 dBm), Mid(0 dBm), Low(-6 dBm)
b. ADV Interval: From 100 ms~1 min.
For iBS03R ToF mode can be choosed (default: Short Range mode)
●
Short Range Mode: for distance < 1.3 meters measurement, power consumption optimized.
●
Long Range Mode: for distance 1.4~3 meters measurement, power consumption as tradeoff.
Waste Electrical and Electronic Equipment Recycling
Our product is compliant with the WEEE directive for re-use/recovery/recycling. This cross-out
wheeled-bin symbol is a reminder that this product should not be treated as household waste. Instead
hand it over to the appropriate collection point for the recycling of electrical and electronic equipment
in accordance with local environmental regulations for waste disposal.
Since our product is not sold directly to the end user and generally it is a part of our customer’s
solution, our customer is recognized as a professional seller. Our customer has the responsibility to
comply with the requirement of the directive too. To help our customers, when necessary, we will
provide a WEEE compliant assessment report for registering and communicating with the local
authorities and recycling agency.
Certification
Japan MIC Regulatory
211-180707
FCC Regulatory
2AH2IIBM40R2
IC Regulatory
21379-IBM40R2
NCC Regulatory
iBS03 CCAJ19LP70E0T0
iBS03G CCAJ19LP70E1T2
iBS03T CCAJ19LP70E2T1
Statement
Federal Communication Commission Interference Statement
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the
FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential
installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in
accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee
that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or
television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct
the interference by one of the following measures: . Reorient or relocate the receiving antenna. . Increase the separation
between the equipment and receiver. . Connect the equipment into an outlet on a circuit different from that to which the
receiver is connected. . Consult the dealer or an experienced radio/TV technician for help.
FCC Caution:
To assure continued compliance, any changes or modifications not expressly approved by the party
responsible for compliance could void the user's authority to operate this equipment. (Example - use only shielded interface
cables when connecting to computer or peripheral devices).
FCC Radiation Exposure Statement
This equipment complies with FCC RF radiation exposure limits set forth for an
uncontrolled environment. This equipment should be installed and operated with a minimum distance of 20 centimeters
between the radiator and your body.
This transmitter must not be co-located or operating in conjunction with any other antenna or transmitter. The antennas used
for this transmitter must be installed to provide a separation distance of at least 20 cm from all persons and must not be
co-located or operating in conjunction with any other antenna or transmitter.
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may
not cause harmful interference, and (2) This device must accept any interference received, including interference that may
INGICS TECHNOLOGY CO., LTD. • [email protected] • WWW.INGICS.COM
4
