Ingersoll-Rand Thermo King Precedent C-600M, Operator'S Manual

Page: 116 / 152

116 TK 56171-2-OP-EN
T Ta akke e IIm mm me ed diia atte e A Accttiio on n:: An alarm condition exists that will damage the unit
or load. Take immediate action to correct the problem.
N No otte e:: The corrective actions listed in the Operating Instructions chapter and
in Table 1, p. 116 are suggestions only. Always consult your company
for final decisions.
N No otte e:: Table 1, p. 116 shows all possible alarm codes for all possible
applications. Not all codes will be applicable to each individual unit.
Not all alarm codes are available with all microprocessor controllers
or all revisions of software.
Table 1. Table of Alarm Codes
COLOR CODE
DEFINITIONS:
OK TO
RUN
CHECK AS
SPECIFIED
TAKE IMMEDIATE
ACTION
Num Description Operator Action
00 No Alarms Exist No action required.
02 Check Evaporator Coil Sensor Manually monitor load temperature.
Report alarm at end of day.
03 Check (Control) Return Air
Sensor Manually monitor load temperature.
Report alarm at end of day.
04 Check (Control) Discharge Air
Sensor Manually monitor load temperature.
Report alarm at end of day.
05 Check Ambient Temp Sensor Report alarm at end of day.
06 Check Coolant Temp Sensor Report alarm at end of day.
07 Check Engine RPM Sensor Report alarm at end of day.
(09) High Evaporator Temperature Manually monitor load temperature.
Report alarm at end of day.
(10) High Discharge Pressure If unit is shut down repair
immediately. Otherwise, report alarm
at end of day.
11 Unit Controlling on Alternate
Sensor Manually monitor load temperature.
Report alarm at end of day.
12 Sensor or Digital Input
Shutdown The unit is no longer able to operate
and has been shut down. Repair
immediately.
13 Sensor Calibration Check Manually monitor load temperature.
Report alarm at end of day.
A Alla arrm m C Co od de ess