18-GJ06D2-2E-EN
5
Unit Design
Table 1.
Cabinet Penetration
Important:
Due to the unique design of this unit, which allows the
electrical wiring to be routed within the insulation, do not
screw, cut, or otherwise puncture the unit cabinet in any
location other than the ones illustrated.
Important:
Under no conditions should metal strapping be attached
to the unit to be used as support mechanisms for
carrying or suspension purposes.
S cre ws ca n be drille d
into bottom of unit.
(1/2” ma x. s cre w
le ngth)
(Typica l a ll s ide s )
S cre ws , s a w cuts , a nd othe r
pe ne tra tions a re a llowe d in
the blowe r s e ction for low
volta ge wiring or ins ta lla tion
of S ide Re turn Kit.
(Typica l both s ide s )
S cre ws a re a llowe d up to 3- 3/4”
from the top of the ca bine t
(he a te r compa rtme nt).
(Typica l both s ide s )
S cre ws for fla nge kit
a tta chme nt a re a llowe d
a long the inte rior of
the ca bine t (s e e a rrows )
(Typica l a ll s ide s )
No pe ne tra tions
a llowe d.
(Typica l a ll s ide s )
S cre ws a llowe d only
in the firs t 3/4” of front
bottom of unit (in
cros s me mbe r)
Table 2.
Panel Removal
The unit contains four (4) access panels: Blower/Filter, Coil, Line Set,
and Heater.
The Blower/Filter panel is removed using 1/4 turn thumb screws.
1.
Turn thumb screws on Blower/Filter panel.
2.
Pull top of panel out, away from cabinet.
3.
Lift panel up out of channel.
4.
Set aside.
