Ingersoll-Rand P105WJD, Operation And Maintenance Manual

Page: 10 / 71

Drawbar Notice
2
Drawbar Notice - This machine may have been shipped from the factory with the drawbar
positioned upright. To convert from Shipping Position to Towing Position.
The following tools are required:
Ratchet and 13mm socket to fit ratchet
Torque wrench set to 68 foot pounds (9.4 kg-meters)
16mm socket to fit torque wrench
5 inch extension for torque wrench
Hardware included: (4) 12mm bolts with pre-applied thread lock, (2) 8mm Taptite
bolts, (2) Washers, (2) Safety Chains
1. Remove hardware box from compressor toolbox.
2. Open box and remove the bag containing hardware, safety chains and assembly
instructions.
3. Using the jack, raise the front of the unit so that the legs are approximately 1 inch
above the ground.
4. Remove the temporary retaining bolts from both sides of the frame at the drawbar
connection (See Fig. 1).
5. Carefully lower drawbar to the Level Position.
6. Install the four bolts (with pre-applied thread lock) to the four points inside the
enclosure and torque to 68 ft. lbs. (9.4kg-m) (See Fig.2).
7. Install safety chains by sliding the second link of one chain into the slot in drawbar
plate. Fasten chain to plate using taptite and washer. Repeat for other chain.