47540139001_ed3
EN-2
EN
Abrasive Installation
WARNING
Always remove the battery pack, before installing, removing or adjusting any accessory
on this tool, or before performing any maintenance on this tool or any accessory.
Backing Pads should be inspected for signs of irregularities such as fractures, excessive
wear, nicks and cuts at the edge of center hole. Pads showing such characteristics
should not be used.
See drawing 1 on page 2.
A
Sanding disc / Polishing pad
B
Backing pad / Hook & Loop pad
C
Spindle lock
For Sanding disc / Polishing pad installation:
1. Press in the spindle lock.
2. Thread backing pad / hook & loop pad onto spindle.
3. Center sanding disc / polishing pad and attach onto backing pad / hook & loop pad.
Switch Lock
The switch lock is an additional safety feature. It locks the trigger and is used when attaching
accessories, storing the tool, or when tool is not in use. See drawing 2 on page 2.
Parts and �aintenance
Tool repair and maintenance should only be carried out by an authorized Service Center.
Refer all communications to the nearest
Ingersoll Rand
Office or Distributor.
Environmental Protection
When life of
Ingersoll Rand
electrical product has expired, it must be recycled in accordance
with all applicable standards and regulations (local, state, country, federal, etc.). Improper
disposal may endanger environment.
Symbol Identification
Li-Ion
Return waste material
for recycling.
Do not dispose of this product
with household waste material.
Product contains Lithium-Ion.
Do not dispose of this product with
household waste material.
Original instructions are in English. Other languages are a translation of the original instructions.
●
●