Ingersoll-Rand ENL 10, Instructions For Installation And Operation Manual

Page: 18 / 96

18 ingersollrandproducts.com 80446222
EN
1. Check whether or not the service unit (9) goes with the
control unit (1...8) (model designation and color of the
arresting hook).
14. Check the O-rings at the new service unit (12, 1).
1. Mount the design shell (11).
16. Mount the service unit along with the design shell at
the condensate receiver tank (19) and tighten both
erection bolts (22) (2, Nm).
17. Re-install the ENL 10 at the inlet tubing and outlet, in
reverse order to disassembly.
Installation of the control unit on the ENL 10:
Check whether or not the service unit with contact
springs (28) is clean, dry, and free from impurities.
Introduce the sensor () into the service unit (9).
Hang the hook (29) of the control unit (1...8) in the
service unit (9).
Press the control unit (1...8) against the service unit (9),
snap into place and make sure it is securely mounted.
1.
2.
.
4.
Start-up subsequent to maintenance measures:
Always carry out prior to the start-up:
Leak test of the screwed connector of the condensate
receiver tank and of the connection of this tank to the
service unit.
Check of the electrical connections.
Check of the correct engagement of the control unit.
•
•
•
11. CONTROL AND mAINTENANCE