Ingersoll-Rand Club Car VILLAGER 6 ELECTRIC, Operator'S Manual

Page: 36 / 88

Page 34
VILLAGER 6 ELECTRIC
Operators Manual
TPCC01BO00EN021 (Edition B)
Amber
(Constant)
AC power sensed.
Amber
(Flash On And Off)
Low AC Voltage. Check voltage and power
cord length.
Red
(Flash On And Off)
Charger error. Reset charger power and refer
to troubleshooting instructions.
INSPECTION AND SERVICE
ALGORITHM PROGRAM NUMBER
To find the algorithm program number:
1. Disconnect the AC electrical cord from the outlet.
2. Set the Tow/Run switch to TOW.
3. Disconnect the battery cable from battery number 8 negative (-) post.
4. Plug the AC electrical cord into an approved power source. Let the battery charger to do the
start-up self-test.
5. When the start-up self-test is done the 80% LED will show a sequence of flashes that represent
the algorithm number.
Note: One flash, pause, two flashes, pause, and five flashes would be an example of Algorithm
number 125.
6. Repeat Step 1 through Step 4 to see the algorithm code again.
ELECTRICAL CORDS
Examine electrical cords for wear and damage before use. Immediately replace electrical cords for:
• Cracks
• Cuts
• Frayed wiring
• Insulation damage
• Loose connections
• Splices
5
Battery Charger
Inspection And Service