Ingersoll-Rand Club Car Carryall 272, Owner'S Manual

Page: 31 / 44

Engine Oil Level Check
2007 Carryall 272/Turf 272 Gasoline Vehicle Owner’s Manual (Europe) Page 29
12. Tighten the oil filter by hand until tight. Do not use a band wrench or channel lock plier to tighten.
13. Remove the dipstick and add engine oil into the dipstick port. Use a funnel or pour spout to direct the oil
into the dipstick port. With filter change, the engine requires 38 ounces (1.12 liters) of oil per change.
Refer to oil viscosity guidelines for selection of oil grade
(Figure 19) . Replace the dipstick.
14. Connect the battery cables, positive (+) cable first, and tighten terminals to 12 ft-lb (16 N·m). Coat ter-
minals with Battery Terminal Protector Spray (CCI P/N 1014305).
15. Lower the cargo bed. See WARNING “For vehicles with cargo beds...” on page 8.
16. With the Forward/Reverse handle in the NEUTRAL position, start and run the engine for a few minutes.
Observe both the drain plug and the oil filter from under the vehicle and watch for oil leaks. If leaks
appear, begin with step 1 and repeat the appropriate step for either or both items to correct the problem.
17. Remove the dip stick and check the engine oil as a final step. Replace the dip stick.
OIL VISCOSITY
Choose the viscosity according to the temperature as indicated by the oil viscosity chart (Figure 19) . See fol-
lowing NOTE.
NOTE: Using multi-grade oils (5W-20, 10W-30, and 10W-40) will increase oil consumption. Check oil level
more frequently when using them.
Figure 17 Remove Engine Oil Filter Figure 18 Coat Oil Filter Rubber Seal
Figure 19 Oil Viscosity Chart
USED OIL FILTER
OIL DRIP GUARD
DRAIN PAN
°
°
° ° ° ° ° °
C
° ° ° °
°
°
°
-20 C -10 C 0 C
10 C
20 C
-4 F F 32 F
68 F
86 F 104 F
SAE 5W-20
SAE 10W-30/SAE 10W-40
SAE 30
SAE 40
30 40
14
50 F