Ingersoll-Rand Club Car Carryall 272, Owner'S Manual

Page: 30 / 44

Engine Oil Level Check
Page 28 2007 Carryall 272/Turf 272 Gasoline Vehicle Owner’s Manual (Europe)
ý
WARNING
• Do not attempt to change engine oil when the engine is hot or even warm. Engine oil can
cause skin burns.
• Wear safety glasses or approved eye protection when servicing the vehicle. Wear rubber
gloves when handling oil drain plug, oil filter, and oil drain pan.
6. Clean the oil drain plug threads with solvent to remove oil and oil residue. Make sure that the compres-
sion washer remains on the drain plug.
7. Use a 14 mm socket or wrench and replace the front oil drain plug, turning it clockwise, and tighten to
18 ft-lb (24.4 N·m).
8. Relocate the oil drain pan to a position under the engine oil filter (Figure 16) .
9. Remove the engine oil filter, turning it counterclockwise, allowing the residual oil in the filter port and filter
to drain into the oil drain pan (Figure 17) . See following NOTE.
NOTE: An oil drip guard can be used to prevent excess oil from dripping into the engine base plate. Use
an empty quart (one liter) container and cut the bottom off at an angle, then slide the open area of
the container up and under the oil filter prior to removing. Position the port of the plastic container
so oil will be directed into the oil pan
(Figure 16) . Or, make a drip guard by folding a piece of card-
board, thin metal, or plastic under the oil filter forming a channel to direct the filter port oil into the
drain pan.
Dispose of used oil according to the environmental laws and regulations for your area.
10. Use a clean rag and wipe the oil filter mounting bracket surface clean where the oil filter gasket seats.
11. Install a new oil filter (CCI P/N 1016467) onto the engine oil filter port. Apply a light coat of white lithium
NLGI Number 2 grease (Dow Corning
®
BR2-Plus or equivalent) or new engine oil to the rubber seal
around the outside surface of the filter before attaching it to the oil filter port (Figure 18) . This will help
seal the filter to the oil mounting bracket.
NOTE: Use only Club Car oil filters (CCI P/N 1016467) designed for this engine.
Figure 16 Engine Oil Drain Plug and Pan
OIL FILTER
DRAIN PAN
DRAIN PLUG