Ingersoll-Rand 317A, Product Information

Page: 3 / 60

04580395_ed3 EN-1
EN
Product Safety Information
Intended Use:
This Sander is designed for light sanding, feather edging and rust removal.
For additional information refer to Rotary Air Sander, Polisher and Buffers Product Safety
Information Manual Form 04580387.
Manuals can be downloaded from www.ingersollrandproducts.com.
Product Specifications
Model
Free Speed
Pad
Diameter
Sound Level dB (A)
(ISO15744)
Vibration
(ISO28927) m/s
2
rpm inch mm † Pressure (L
P
) ‡ Power (L
W
) Level *K
317A 18000 5 127 86.7 99.7 3.3 0.8
† K
pA
= 3dB measurement uncertainty
‡ K
wA
= 3dB measurement uncertainty
*K = Vibration measurement uncertainty
Installation and Lubrication
Size air supply line to ensure tool’s maximum operating pressure (PMAX) at tool inlet. Drain
condensate from valve(s) at low point(s) of piping, air filter and compressor tank daily. Install a
properly sized Safety Air Fuse upstream of hose and use an anti-whip device across any hose
coupling without internal shut-off, to prevent hose whipping if a hose fails or coupling
disconnects. See drawing 16578577 and table on page 2. Maintenance frequency is shown in
circular arrow and defined as h=hours, d=days, and m=months of actual use. Items identified as:
1. Air filter 6. Thread size
2. Regulator 7. Coupling
3. Lubricator 8. Safety Air Fuse
4. Emergency shut-off valve 9. Oil
5. Hose diameter
Sandpaper Installation
WARNING
Disconnect the air supply before servicing or changing the sanding pads.
Backing Pads (16) should be inspected for signs of irregularities such as fractures,
excessive wear, nicks, cuts, at the edges of center hole. Pads showing such
characteristics should not be used.
Aluminum oxide, resin bond abrasive paper is recommended. Paper can have 7/8” diameter
center hole, or pressure sensitive adhesive.
Select Proper sandpaper and pad for application. Use either resin-backed or pressure-sensitive
sandpaper.
•
•