2
WARNING LABEL IDENTIFICATION
FAILURE TO OBSERVE THE FOLLOWING WARNINGS COULD RESULT IN INJURY.
Always wear eye protection
when operating or perform-
ing maintenance on this tool.
WARNING
WARNING
Always wear hearing
protection when operating
this tool.
Always turn off the air sup-
ply and disconnect the air
supply hose before install-
ing, removing or adjusting
any accessory on this tool,
or before performing any
maintenance on this tool.
WARNING
Air powered tools can vibrate
in use. Vibration, repetitive
motions or uncomfortable po-
sitions may be harmful to your
hands and arms. Stop using
any tool if discomfort, tingling
feeling or pain occurs. Seek
medical advice before resum-
ing use.
WARNING
Do not carry the tool by the
hose.
WARNING
WARNING
Do not use damaged, frayed
or deteriorated air hoses
and fittings.
WARNING
Keep body stance balanced
and firm. Do not overreach
when operating this tool.
WARNING
Operate at 90 psig (6.2 bar/
620 kPa) Maximum air pres-
sure.
90 psig
(6.2bar/620 kPa)
International Warning Label:
Order Part No. ___________
PLACING TOOL IN SERVICE
LUBRICATION
Ingersoll–Rand No. 10
Ingersoll–Rand No. 67
Always use of an air line lubricator with these tools.
We recommend the following Filter–Lubricator–Regulator
Unit:
For International– No. C28–C4–FKG0
For USA– No. C28–04–FKG0–28
Before starting the tool, unless an air line lubricator is
used, detach the air hose and inject about 1.5 cc of
Ingersoll–Rand No. 10 Oil into the air inlet.
After every 150 hours of operation, remove the Bearing
Housing (35) and lubricate the Pinion (24) and Pinion
Gear (32) with 30 cc of Ingersoll–Rand No. 67 Grease.
MAIN LINES 3 TIMES
AIR TOOL INLET SIZE
TO
AIR
SYSTEM
TO
AIR
TOOL
LUBRICATOR
REGULATOR
FILTER
BRANCH LINE 2 TIMES
AIR TOOL INLET SIZE
DRAIN REGULARLY
COMPRESSOR
(Dwg. TPD905–1)
SPECIFICATIONS
Model
Free Speed
Spindle and
Back up Pad
H
Sound Level
dB (A)
♦
Vibrations Level
rpm
Pressure
•
Power
m/s
2
313, 313–EU
5,000
5/8” – 11, 7”
99.3
112.3
1.6
314, 314–EU
5,000
5/8” – 11, 7”
97.3
110.3
2.0
H
Tested in accordance with ANSI S5.1–1971 at free speed
♦
Tested in accordance with ISO8662–1 sanding on steel workpiece
•
ISO3744
