Ingenico iWL 250 series Set-Up Guide
Page
2
of
5
SYSTEM SET-UP
Press
ADMIN
to access
Admin menu
Select 3 for
SET-UP
, press OK
Select 3 for
SYSTEM SET-UP,
press OK
Enter Admin password, press OK
TERMINAL DATE
will be set automatically by host
TERMINAL TIME
will be set automatically by host
Set
MAIN COMM
Mode to Ethernet or Dial
If communication mode is Dial set the following configurations:
Set
DIAL PREFIX
(commonly 9) if required
Set
DIAL TYPE
to Tone or Pulse
Set the
LINE DETECTION
to Yes/No
Set the
BAUD RATE
to 1200 or 2400
Set
ENABLE PRE-DIAL
for Debit to Yes/No
Set
ENABLE PRE-DIAL
for Credit to Yes/No
Set
DIAL PARITY
to None/Even
Set
DATA SIZE
to 7 or 8
Set
DIAL STOP BITS
to 1 or 2
For
ETHERNET
Yes when prompted for username and password simply enter OK
Set the wireless
ACCESS POINT
to network provider (on SIM card):
Telus: isp.telus.com
Rogers: internet.com
Bell: pda.bell.ca
For
ETHERNET SETUP
choose Ethernet
For
DNS SETUP
choose automatic Yes/No
If Automatic DNS is set to Yes press OK
If Automatic DNS is set to NO:
Enter primary and secondary IP addresses
For
TERMINAL SET-UP
choose None/Dynamic/Static
If Set to
STATIC:
Enter Mask IP, press OK
Enter Gateway Address, press OK
COMMUNICATION TO HOST SET-UP
Press
ADMIN
to access Admin menu
Press 3 for
SET-UP
Press 2 for
HOST SET-UP
Enter new Admin password, press OK
Enter the 8 digit
TERMINAL ID
(TID), press OK
Select Ethernet for
COMMS
Setup
Set
FALLBACK TO DIAL
to Yes if required
All of the communication parameters come pre-configured.
To validate the configurations following the instructions below:
Select
INPUT
Type
IP
address should set at 206.152.27.137
NAME
should be set at www.ctpaiement.com
PORT NUMBER
should be set at: 5085
